Back to shop
Kitchen & Bath
Vase-Mode Funnel Set
₹99 + shipping & GST at checkout
A set of single-wall funnels printed in vase mode — refill bottles and jars without the spill, for a few grams of filament.
Color
PETG is tougher and more chemical-resistant than PLA at the same ₹4/g, and holds up to about 75 °C. It is the right pick for outdoor, wet, mechanical or food-adjacent parts, and comes in Black or White only.
7–10 business days end to end: about 3–5 days to print and 2–5 in transit with Delhivery, which reaches 19,000+ PIN codes. Your exact cost and days are shown at checkout for your PIN code.
Printed at 0.2 mm layers with 20% infill, and inspected before shipping. Visible layer lines, slight stringing and a tolerance of about ±0.3 mm are normal characteristics of FDM printing rather than defects.
- Secure payment
- Tracked shipping
- GST invoice
Material PETG (premium)
Weight ~9.22 g
Layer height 0.2 mm — inspected before shipping
About this print
A parametric funnel set printed in single-wall vase mode, so each funnel uses only a few grams of filament and finishes fast while staying fully watertight. Use it to refill oil bottles, transfer dal or rice into jars, top up a flask — any pour that tends to make a mess. A 4.9★ community design with 3,400 documented makes. Printed in food-safe PETG, which shrugs off oils and hot liquids far better than standard prints. Hand-wash only; not for prolonged food storage.
Designed by DrJones — original model on MakerWorld. Licensed CC-BY.